* Add Human pose estimation drone control project to the documentation in Gitbook
* Update human_pose_estimation_drone_control.md
* Update human_pose_estimation_drone_control.md
* Change the videos links
* Update human_pose_estimation_drone_control.md
Fix markdownlint warnings
* Reduce the size of poses image
* Added a photo of 3d-scanning drone
* Added a new article about 3d-scanning drone.
* Updated the article
* Included the new article about 3d-scanning drone.
* Added a new article.
* Included a new article
3D-scanning drone
* Fixed bugs
* Fixed md syntax
i'm affraid i did not translate correctly the part at line 92:
the speed will be controlled such as Optical Flow "values"? do not exceed 50% of the "given parameter"?
copter = helicopter, use drone.
blanch is not the correct term, use to tin which is widely used.
Flat cable is used but I beleive ribbon cable is more common (not sure)
Unclear sections (did not understand in russian neither, coming from an unadviced reader it might be usefull to clarify those points)
- l.61 "the red and black wires are to be tinned on both ends using tweezers" (did you mean soldering iron?)
- l.82 "disconnect the power and move yellow jumper to the other tweezer" (did you mean pins)
- l.145 "thus, it will be clear which motor is controlled" (unsure if by going through the procedure we activate the motors individually or by setting the throttle to 10% we simply see the direction of spin as it's slow)
not linked to the proof reading:
do you power the rgb strip directly from the raspberry pi with pin 40 (gpio 21) ?because it can be dangerous as the led strip is drawing x mA or even x A, and the RPI is not designed to withstand such currents (I beleive not more than 500mA), be carefull :o
- Copter in English is a synonyme of helicopter, use drone or quadrocopter.
- I would modify ther term "additionnal frame" as it might be understood as spare frame. I would describe them as "top frame" "bottom frame" "main frame" etc.
